log in registered
English

English

what are you looking for?

Blog
blog

b

home |

blog

  • How to implement battery monitoring in a deployable product?

    How to implement battery monitoring in a deployable product?

    Nov , 27 2021
    Standalone ohmic battery monitoring systems designed for data center application are not suited for a genset environment. Although ohmic monitors work, they are expensive (estimated at $2,000 for a 24-volt system), time-consuming to install, and require trained personnel to interpret their data output. To achieve widespread adoption in the genset market any battery monitoring technology will need ...
    more

  • What are the recharge cycles phases of a Lead acid battery?

    What are the recharge cycles phases of a Lead acid battery?

    Nov , 27 2021
    The fastest generally accepted way to charge a conventional (lead‐acid or NiCd) battery is with a constant voltage, a current limited battery charger that is capable of both “boost” and “float” output voltages. “Boost” charging applies a higher than normal voltage to the battery early in the charge cycle to charge the battery as quickly as possible. Later, once the battery is charged, charging vol...
    more

  • What is the right duration of Phase 2 of a charging cycle?

    What is the right duration of Phase 2 of a charging cycle?

    Nov , 27 2021
    The duration of Phase 1 is determined by the battery’s depth of discharge, the ratio of charger ampacity to battery capacity, and whether there are parasitic DC loads connected to the system. Although the duration of Phase 1 does vary, we are not concerned with this variation since, once the battery capacity, charger output, and DC loads are installed, we have no means to change the duration of Ph...
    more

  • Shortcomings of automatic boost timers (Method C) and current‐sensing automatic systems (Method D)

    Shortcomings of automatic boost timers (Method C) and current‐sensing automatic systems (Method D)

    Nov , 27 2021
    In the automatic timer control scheme, the duration of the boost charger is pre‐programmed into the charger’s control system. Chargers equipped with automatic boost timers may, under very specific circumstances, provide just the right duration of boost charging. Under all other circumstances, however, such as a different depth of discharge, or when the connected DC load changes, the pre‐programmed...
    more

  • What is Dynamic Boost and how does it works?

    What is Dynamic Boost and how does it works?

    Dec , 03 2021
    As with the current‐controlled automatic boost system, Dynamic Boost includes no pre‐programmed boost timer. Unlike the current‐controlled automatic boost system, however, Dynamic Boost automatically adjusts boost duration to take into account differing parasitic DC loads and other variables discussed above. The principle behind Dynamic Boost is simple and straightforward. Refer back to Figure 1. ...
    more

  • Why Boost Charging is Necessary?

    Why Boost Charging is Necessary?

    Dec , 06 2021
    Boost charging is a very necessary activity during the operation of a VRLA battery in their life time. In this article we are going to discuss about the necessity of Boost charging in details. The following example helps illustrate two facts about reducing battery recharge time: Cutting recharge time in half is more complex than using a charger that delivers twice as many amperes. Multi‐rate charg...
    more

  • Why flooded SLI batteries in GENSET applications fail sooner and more suddenly than in vehicle applications?

    Why flooded SLI batteries in GENSET applications fail sooner and more suddenly than in vehicle applications?

    Dec , 06 2021
    Continuous float charging flooded SLI batteries accelerates the deterioration of polyethylene plate separators to a life shorter than that which battery designers intended. When subjected to continuous float charging, the dominant and earliest failure mode tends to be premature failure of the polyethylene separator. Separator failure typically results in short circuits that prevent the battery fro...
    more

  • How a new intermittent charging algorithm addresses premature SLI battery failure?

    How a new intermittent charging algorithm addresses premature SLI battery failure?

    Dec , 06 2021
    A new charging algorithm addresses the problems of short genset battery life and sudden battery failure discussed above, while meeting the regulatory needs to deliver non-stop DC power to critical applications. The principle is simple and straightforward. Emulate the beneficial intermittent vehicle charging regime for which SLI batteries were originally designed, but continue charger operation to ...
    more

  • What is a portable power station?

    What is a portable power station?

    Dec , 24 2021
    A portable power station provides an individual with an easy source of energy to use wherever they are. If you spend a lot of time outdoors and you’d like to have some energy available to use while you do, then purchasing one of these devices could be a great decision. A portable power station is like a generator that’s easier to use and maintain. These devices include rechargeable batteries ...
    more

  • Some common question answers for Portable Energy storage solutions

    Some common question answers for Portable Energy storage solutions

    Dec , 24 2021
    As a leading energy storage solutions provider, we always get asked a varieties of questions by our valuable customers and partners, here in this article we have accumulated a few of them and tried to answer them accordingly. How long can I use my portable power storage to power my devices? First, you need to check out your device's operating power (measured by watts). If it is less than the outpu...
    more

  • Which battery is suitable for your application?

    Which battery is suitable for your application?

    Dec , 30 2021
    As a leading energy storage solutions provider, we offer various types of maintenance-free batteries, each with its own specific characteristics. More information hereafter about the properties of gel, AGM and Lithium Ion batteries. The Gel battery With flooded lead-acid batteries, which use a liquid electrolyte of water and sulphuric acid, the water is separated into hydrogen and oxygen during ch...
    more

  • Some frequently asked questions for Batteries-Part 2

    Some frequently asked questions for Batteries-Part 2

    Dec , 31 2021
    From our long experience of providing battery solutions to our customers and partners, we have seen that there are some basic questions that are always asked. Here we are sharing some of the common questions and their answers regarding the batteries for your convenience. What not to do with Gel, AGM and Lithium Ion batteries Incorrect charge voltage. Too low a voltage means that the battery cannot...
    more
first page << 1 2 3 4 5 6 ... 11 >> last page

a total of11 pages

Are you looking for more information about EverExceed's  professional products and solutions?  Our expert team is always here to help. Please fill in the form and our sales representative will contact you shortly. EverExceed | Empower, Energize, Exceed the Energy you Expect forever.
Leave a message
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.
Contact us

EverExceed Industrial Co., Ltd

copyright © 2024 EverExceed Industrial Co., Ltd.all rights reserved.
leave a message
welcome to everexceed
If you are interested in our products and want to know more details,please leave a message here,we will reply you as soon as we can.

home

products

about

contact